How to Apply Gain, Phantom Power 48v and Phase on the Behringer X32

X32 Aes Preamp Gain Foh. BehringerX3240channelDigitalMixerwith32GainProgrammableMic I just tried the preamp controls in the config screen and found I was wrong The trim function can/should be used if needed, but never the preamp gain setting

I've done analog splits to both preamps, so I can hotswap soft patches between them with same gains etc so you would need to remote control the X32R from FOH to get access to headamp gain.

LV1 with STG2412's for FOH, feeding XWSG in X32 for MON YouTube

And for the record the DL151 definitely has Midas PRO preamps, in case you're skeptical about the DL16 and DL32 The preamp controls for this configuration are the AES50A 1 through 32 on the X32 primary console So for your example, since the X32 Rack is in between the stageboxes and X32 FOH, it would control all of it's preamps as well as the stageboxes downstream.

Routing, AES 50, stagebox da X32 Behringer e M32 Midas. YouTube. The second X32 will receive the signal digitally through the AES50. The X32's outputs are then still free to be used for the IEM mixes

X32 vs M32 Preamp Noise & Gain vs Trim (Members) YouTube. so you would need to remote control the X32R from FOH to get access to headamp gain. That being said, other than the preamp settings (preamp gain, phantom power, etc), the two boards will have independent control over all the inputs